I've been holding off answering this a few days. Thought I was gonna get the opportunity to take a picture or two, probably can't happen til tuesday AM. So here is my best description:
Welded was wrong word, brazed is correct. Its a 1/4 inch copper tube. It is brazed to the bottom lip of the window channel, to the seam at the back inside corners of the elky & thru a small hole in the floor. The entry hole is behind (under) the rear window trim so it doesn't see too much debris. I watch for water to drip out when I wash the car. Make any sense????
On 8/24/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
In a message dated 8/24/2005 7:15:09 PM Central Daylight Time, [EMAIL PROTECTED] writes:
Welded tubes in the rear window channel.
how big are the tubes?? whats to stop them from plugging with sand,dirt, leaf debris??
--
Rick Schaefer
72 TPI El Camino
