[Chevelle-list] Global West.

[Dan Mascheck]

Clint,     I have been in touch with Global West about using all their parts for a complete front and rear suspension make over! It’s going to cost over $5000 for the top of the line fix(CAT 5) excluding labor.   There has to be some work done on the 12 bolt. C clip eliminator installed and special press on Ford bearing in the diff and some special axles. Something about the 12 bolt not working correctly with the Wilwood 4 piston brakes! Does this sound correct to you? I wish I would have known all this before I rebuilt the 12 bolt!   I will use the  taller spindles. They say it only lowers the car 1”, which….I think I can live with that. I wouldn’t want to go lower! I am going standard suspension, not coil overs. They seem to be a little negative about the QA1 coil overs. They like the dual adj. Shocks, it’s their springs they don’t like, although they substitute their own springs for QA1’s. They say they are too soft!   What did you pay for your air ride suspension? Any advice? Would I be better going with a shockwave system? Cheaper?   From: Clint Hooper [mailto:[EMAIL PROTECTED] Sent: Monday, November 14, 2005 1:37 PM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] Sanderson Headers   I can't comment on how they will fit individual years but they were an easy install on my 68 El Camino w/BBC. They are shorter than a long-tube header (the collectors end at the bottom of the firewall) and their tube size is 1 7/8" (instead of 2" or 2 1/8" like my long tubes). If your car has a SBC,they will practically fall on. Yes,I liked the ball-joint collector flanges much better than the three-point flanges,too. Hedman and Patriot also make intermediate headers for our cars but they won't clear the Z-bar on manual trans A-bodies. Clint Hooper H&H Custom,owner 1969 El Camino ProTourer 2001 H-D FLHR custom bagger http://dalesplace.com/misc/friends/clint/clint_hooper.htm ----- Original Message ----- From: Jimmy C.   Clint, do you know  or hear how they (the sandersons) fit the 72 chevelle ?  height is not an issue for me. and I like the look of the flanges under the car. but want to avoid dinging the pipes and painless installation would be nice too. any suggestions? thanks , Jimmy.C ----- Original Message ----- From: Larry Shouse To: Chevelle List Sent: Saturday, November 12, 2005 9:07 PM Subject: [Chevelle-list] Sanderson Headers   Hey Clint,   I bought a set of Sanderson's BB3 headers for my 66. With my engine almost complete now, I attached the headers to see how they fit. As you know, the driver's side is real short and drops straight down, whereas the passenger side is much longer and doesn't drop nearly as quickly.   From your memory, how close does the passenger side collector get to the firewall? And do you recall any heat or clearance issues?   Thanks, Larry Shouse