|
Ive wondered about the coils on my 65 chevelle. When we
were kids we put spacers in them to raise the car. I would like to
raise the front end about 2" higher than factory and the rear as well.
any ideas would help.
Bob
65 SS
-------Original
Message-------
Date:
12/27/05 18:57:10
Subject:
Re: [Chevelle-list] Front coil springs
Also remember that any coils cut off equal a stiffer
spring. (higher
compression rate)
Brian
>Subject: Re: [Chevelle-list] Front coil springs
>Date: Tue, 27 Dec 2005 19:52:52 -0500
>
>It's a much better option than heating the coils, but
not as good as buying
>lowering springs.
>If you do decide to do this, use a method other than
flame cutting, such as
>abrasive wheel, cold saw, etc...
>
>Just remember, don't cut off too much at once, a 3"
cut on the spring, DOES
>NOT equate to 3 inches of drop.
>
>Dan McIntosh
>1960 Impala Sport Coupe
>Street Metal Fabrications
> ----- Original Message -----
> From: Chevelle List
> To: The Chevelle Mailing List
> Sent: Tuesday, December 27, 2005 7:34 PM
> Subject: [Chevelle-list] Front coil springs
>
>
> Hi Everyone....Hope you all had a great Christmas
and got a few parts
>for yourselves under the tree...
> I was reading on a website(can't remember which one
now) that some
>people have actually cut a few coils off their front
springs to lower their
>cars a few inches....Has anybody here done this and is
it a safe thing to
>do..???..I have seen drop spindles and such for
lowering but haven't heard
>of slicing a coil or two off your front spring.....
> John
_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar – get it now!
|
