Time slips! ;-) Karl Groves Master Certified CIW http://www.karlgroves.com
Will Work For Parts: http://chevelle.karlcore.com/detail.php?id=3 > -----Original Message----- > From: D.R. Jones [mailto:[EMAIL PROTECTED] > Sent: Thursday, February 16, 2006 6:21 PM > To: [EMAIL PROTECTED]; The Chevelle Mailing List > Subject: Re: [Chevelle-list] carburetor suggestion > > What slips you looking for? Engine was built by a speed shop > that has moved from Fort Worth to Cedar Hill, TX > > Karl Groves wrote: > > > DR - > > > > Do you have any slips for that car? > > I'm looking at producing the same numbers with deeper gearing. > > As I look outside to a half-assembled car, covered in snow, > I'd like > > the inspiration! ;-) > > > > Karl Groves > > Master Certified CIW > > http://www.karlgroves.com > > > > Will Work For Parts: > > http://chevelle.karlcore.com/detail.php?id=3 > > > > > >>-----Original Message----- > >>From: D.R. Jones [mailto:[EMAIL PROTECTED] > >>Sent: Wednesday, February 15, 2006 5:55 PM > >>To: The Chevelle Mailing List > >>Subject: Re: [Chevelle-list] carburetor suggestion > >> > >>I have almost the same motor with a 2004R non-lockup trans (B&M) and > >>3.73 posi. I'm running 750 Performer and Performer intake. > >>Motor dyno at 500HP and 500 torque. Will change intake to > Performer > >>Air Gap soon. > >> I psersonally like the Performer carbs rather than > Holley's. Course > >>that is just what I like. > >> > >>D.R. Jones > >> > >>Jimmy C. wrote: > >> > >> > >>>I'm am shopping for a carburetor and looking for > >> > >>suggestions. I have a > >> > >>>454 ci that is 60 over , with flat top pistons not quite sure of > >>>compression. 113cc oval port heads ,it has comp cam with .526 lift > >>>int. & ex, duration is 230 deg., lobe seperation is 110 deg, stock > >>>valve train, edelbrock performer 2.0 intake. appreciate all > >>>suggestions. thank you ,Jimmy .C > >> > >> > >> > >> > > > > > > > > > > >
