Dave, The numbers I would get will be Carquest P/N's. When I did my rear, I just told them which parts I needed and they provided them. I have replaced the axle seals twice,since I narrowed the rear last fall and bought Moser axles. But I have had no issues getting the correct parts. Your center housing should have a casting number and a date code.  This would narrow down the possible rears that could have been put in your car. If it is a BOP and non c clip rear I am pretty sure it would be 66 or earlier.
Mike 
----- Original Message ----- From: Dave Corgill
Sent: Thursday, May 25, 2006 9:14 AM
Subject: Re: [Chevelle-list] looking for a yoke seal 8.2 Pontiac rear end

At 07:23 AM 5/25/2006, you wrote:

Dave, The rear could be something different than we thought. My BOP 10 bolt is a 64 and original to my car. My 64 GTO has exactly the same rear. I think we assumed your rear was a 66 BOP. Could it have been changed out by a previous owner?

Must have been.

I'll be at my local parts store later today and can get part numbers for my rear, axle bearing, seals etc. But yours may be different. Can you read any numbers off the center housing that might be casting numbers or date codes? Is there an axle code stamped on the RS axle tube? These may help with positive ID.
Let me know if I can help.
Mike



I looked on top passenger tube & couldn't find any numbers. i
can look again in the morning.
Your #'s would help, I bet the axle bearing on yours is
RW-507-CR I can find these, but mine is RW-507-G or RW-507-GR.

It's much bigger diameter OD & ID.
thanks.


Here in Dallas they have no idea. I can't find the axle bearings
anywhere. Seems they are not available anywhere. & I have spent
hrs on the phone. The ones that I can get are to small RW-507-CR.
RW-507-CR are 2.749 OD X 1.380 ID.

I need RW-507-G  2.890 OD X 1.437 ID & .740 thick, sealed ball
bearing . I can even use used ones (can be re-packed).

Help! Maybe I should have bought a Ranchro F**D , sorry I cussed.
Why my 66 Elky ended up with this rear end I don't know...


No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.7.1/347 - Release Date: 5/24/2006

Reply via email to