|
It's when I floor it or give it gas very
quick!
If I sort of coax it or give it gas very gently i
can get pass the "dead" zone.
The vacum canister should be ok since the distr is
a brand new HEI.
Is there any tuning to do with an "out of the box"
HEI distr?
Float levels are approx in the center of the sight
plug!
Pelle
----- Original Message -----
Sent: Monday, July 24, 2006 2:38 PM
Subject: Re: [Chevelle-list]
Hesitates!
Have you checked your vacuum advance cannister? Just want to
make sure that it isn't sticky inside and can release when you open the
throttle.
Now when you say it hesitates, does it do it when you just floor it, or
does it do it when you just ease into the throttle? Or both?
-Shawn
On Jul 24, 2006, at 8:00 AM, Pelle Andersson wrote:
Hi
again!
I turned
the distr 180 degrees & installed i by the book!
I've
adjusted the ignition back & forth & finally decided that 10 degrees
was best!
The
hesitation is much shorter now & the engine comes with full power after
it
picks up
again, but it still hesitates :-/
Pelle
----- Original Message
-----
Sent:
Sunday, July 23, 2006 5:53 PM
Subject: Re:
[Chevelle-list] Hesitates!
I tried
that & it got marginally better!
I have
adjusted the fuel bowl level "by the book"
Since
my dist is 180 degrees "off" I have to fix that first
so I
can use a lamp to adjust the ignition!
I'll be
back
Pelle
----- Original Message
-----
Sent:
Saturday, July 22, 2006 5:03 PM
Subject: Re:
[Chevelle-list] Hesitates!
Try
advancing the timing about 4 degrees.
Tom
|
- Re: [Chevelle-list] Hesitates! Pelle Andersson
-
