Ho Hugh,
Try using Copy & Paste in Chirp itself, without bothering to export to a
spreadsheet.
Download a fresh copy of the GT3 config from the radio. Copy (as in cmd-C)
the config lines from the GT3. Change radios. Then get a fresh download from
the GT5 (The GT5 download should create a new tab in Chirp) Paste (cmd-V) the
lines you want to ‘clone’ from the GT3 config onto the GT5 config page,
ove-writing lines as needed. Just highlight the starting line where you want
the lines from the GT3 to start). The upload the modified config back into
the GT5.
It doesn’t hurt to save the original GT5 config that was just downloaded just
in case you don’t get a satisfactory result and wish to restore.
/CB
KE4QBW
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]
