I have a cable that I can unplug from the USB and connect another cable, but I just looked at and it is also a male that goes into the USB part, and the three single cables that came with the set are male at both ends, so there's no way to join them. My cable kit also came with two two pin plugs, and only one of those fit the Baofengs, and that is what I was using. I was just looking in the BF F9u+ manual and it mentioned cloning from one to the other, but I only have a UV5R to clone from, and it might not be good to clone between different models anyway. I thought I'd look for some Baofeng software, but I don't find a download link on their site, maybe their site isn't screenreader friendly. Glenn ----- Original Message ----- From: "Nigel A. Gunn G8IFF/W8IFF" <[email protected]> To: "Discussion of CHIRP" <[email protected]>; "K0LNY_Glenn" <[email protected]> Sent: Tuesday, July 19, 2022 7:47 PM Subject: Re: [chirp_users] Baofeng HP9+ won't read
My cable has plugs for both ports. > On 19/07/2022 20:35 EDT K0LNY_Glenn <[email protected]> wrote: > > > So far, I have had no luck, I have some cables that came with one of my > cables that might work for a cloning cable. > Would the cloning happen on the smaller port or the larger port? _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected] To report this email as off-topic, please email [email protected]
