Actually I made a silly mistake. The printers should be set up. At present,
the LL2pcl is the default printer. But if that does not work, try the
LL2raster printer instead.
William G. Unruh __| Canadian Institute for|____ Tel: +1(604)822-3273
Physics&Astronomy _|___ Advanced Research _|____ Fax: +1(604)822-5324
UBC, Vancouver,BC _|_ Program in Cosmology |____ un...@physics.ubc.ca
Canada V6T 1Z1 ____|____ and Gravity ______|_ www.theory.physics.ubc.ca/
On Mon, 29 Jun 2020, Miroslav Lichvar wrote:
On Fri, Jun 26, 2020 at 04:22:55AM +0000, saga m wrote:
When will the kernel set the unsychronized status again, it seems that I have
to excute 'adjtimex -S 0 -m 0' periodically as you mentioned
When the maximum error, which is increasing at a rate of 500 ppm,
gets to 16 seconds. That takes 16 / 500e-6 = 32000 seconds.
On Fri, Jun 26, 2020 at 09:46:07PM +0800, xqmen...@hotmail.com wrote:
I opened the built-in log in chronyd and after several hours the
synchronization status becomes no. But the stratum didn't increase too high,
as I use
local stratum 10 in chrony.conf as its initial value, the straum just
increase by 1.
chronyd[10693]: ntp_core.c:1686:(receive_packet) NTP packet lvm=44
stratum=11 poll=10 prec=-24 root_delay=0.000031 root_disp=0.034988
refid=7f000001 []
...
chronyd[10693]: ntp_core.c:1700:(receive_packet) test123=111 test567=111
testABCD=1110 kod_rate=0 interleaved=0 presend=0 valid=1 good=0 updated=1
The test D failed, which means a synchronization loop was detected
before the stratum could get to the maximum of 16. The client checks
if the refid reported by the server is not equal to its address and
this works even on the loopback interface.
--
Miroslav Lichvar
--
To unsubscribe email chrony-dev-requ...@chrony.tuxfamily.org with "unsubscribe"
in the subject.
For help email chrony-dev-requ...@chrony.tuxfamily.org with "help" in the
subject.
Trouble? Email listmas...@chrony.tuxfamily.org.
--
To unsubscribe email chrony-dev-requ...@chrony.tuxfamily.org with "unsubscribe"
in the subject.
For help email chrony-dev-requ...@chrony.tuxfamily.org with "help" in the
subject.
Trouble? Email listmas...@chrony.tuxfamily.org.
