Oh ok I am sorry, I wasn't sure if you were up or not..then it is def not tx/rx issue..
Im stumped sorry :/ |-----Original Message----- |From: Bagosi Rómeó [mailto:[EMAIL PROTECTED] |Sent: Tuesday, April 03, 2007 11:05 AM |To: Koch, Christian; [email protected] |Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH | |The problem is that this link is very important... |I've trusted that will be some other solution for this:( | |You think that if the TX/RX is now inverted, the network works |(with some errors)? | | |-----Original Message----- |From: Koch, Christian [mailto:[EMAIL PROTECTED] |Sent: Tuesday, April 03, 2007 4:56 PM |To: Bagosi Rómeó; [email protected] |Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH | | have you tried swapping out the fiber? Maybe switching tx/rx ? | ||-----Original Message----- ||From: Bagosi Rómeó [mailto:[EMAIL PROTECTED] ||Sent: Tuesday, April 03, 2007 10:53 AM ||To: Koch, Christian; [email protected] ||Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH || ||Hi Christian! || ||I don't tried it, but on the C2924 I cannot change the media |type, only ||on the C2960 side... ||I think the media type on the C2960 is set to auto, and it recognizes ||as SFP. I think this is ok... || ||C2960: Half-duplex, 100Mb/s, link type is auto, media type is |100BaseFX ||SFP || || ||-----Original Message----- ||From: Koch, Christian [mailto:[EMAIL PROTECTED] ||Sent: Tuesday, April 03, 2007 2:44 PM ||To: Bagosi Rómeó; [email protected] ||Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH || ||Try setting the media type under the interface on the 2924? || |||-----Original Message----- |||From: [EMAIL PROTECTED] |||[mailto:[EMAIL PROTECTED] On Behalf Of Bagosi Rómeó |||Sent: Tuesday, April 03, 2007 5:27 AM |||To: [email protected] |||Subject: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH ||| |||Hi all Experts! ||| ||| ||| |||I have the following problem: ||| |||We have two switch connected by fiber cable: ||| ||| ||| |||WS-C2960G-24TC-L:Gi0/21<<<<< >>>>> Fa1/4:WS-C2924M-XL ||| ||| FIBER ||| ||| ||| |||The problem is, that the C2924 Switch sends the following |messages in |||every minute: ||| ||| ||| |||Apr 3 08:11:33.112 MET-DST: %LINK-4-ERROR: FastEthernet1/4 is |||experiencing errors ||| ||| ||| |||On the C2960 I cannot change the duplex or the speed settings. ||| |||On the C2924 I've changed the duplex settings, but: ||| |||- If it's set to duplex auto or duplex full, then |||%CDP-4-DUPLEX_MISMATCH error on the C2960 Switch ||| |||- If it's set to duplex half, then %LINK-4-ERROR on |||the C2924 Switch ||| ||| ||| |||Why the newer Cisco Devices and IOS doesn't support the speed and |||duplex settings? ||| |||Does these errors highly affect the network performance? ||| |||Is there any solution for this problem? ||| ||| ||| ||| ||| |||Thank you in anticipation! ||| ||| ||| ||| ||| |||C2924# sh int fa1/4 ||| |||FastEthernet1/4 is up, line protocol is up ||| ||| Hardware is Fast Ethernet, address is 0004.9a20.63e0 (bia |||0004.9a20.63e0) ||| ||| MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, ||| ||| reliability 250/255, txload 7/255, rxload 1/255 ||| ||| Encapsulation ARPA, loopback not set ||| ||| Keepalive not set ||| ||| Half-duplex, 100Mb/s, 100BaseFX ||| ||| ARP type: ARPA, ARP Timeout 04:00:00 ||| ||| Last input 00:00:06, output 00:00:00, output hang never ||| ||| Last clearing of "show interface" counters never ||| ||| Queueing strategy: fifo ||| ||| Output queue 0/40, 0 drops; input queue 0/75, 0 drops ||| ||| 5 minute input rate 588000 bits/sec, 440 packets/sec ||| ||| 5 minute output rate 2890000 bits/sec, 530 packets/sec ||| ||| 1752297879 packets input, 4205642061 bytes ||| ||| Received 6728883 broadcasts, 0 runts, 0 giants, 0 throttles ||| ||| 5814363 input errors, 5814363 CRC, 0 frame, 58583 |overrun, 61143 |||ignored ||| ||| 0 watchdog, 1817612 multicast ||| ||| 0 input packets with dribble condition detected ||| ||| 2107649242 packets output, 3958607124 bytes, 12 underruns ||| ||| 12023160 output errors, 7511084 collisions, 8 interface resets ||| ||| 0 babbles, 12023160 late collision, 12054327 deferred ||| ||| 0 lost carrier, 0 no carrier ||| ||| 12 output buffer failures, 0 output buffers swapped out ||| ||| ||| |||C2960#sh int Gi0/21 ||| |||GigabitEthernet0/21 is up, line protocol is up (connected) ||| ||| Hardware is Gigabit Ethernet, address is 0018.73ec.5b95 (bia |||0018.73ec.5b95) ||| ||| MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, ||| ||| reliability 252/255, txload 1/255, rxload 6/255 ||| ||| Encapsulation ARPA, loopback not set ||| ||| Keepalive not set ||| ||| Half-duplex, 100Mb/s, link type is auto, media type is |100BaseFX SFP ||| ||| input flow-control is off, output flow-control is unsupported ||| ||| ARP type: ARPA, ARP Timeout 04:00:00 ||| ||| Last input 00:00:00, output 00:00:04, output hang never ||| ||| Last clearing of "show interface" counters never ||| ||| Input queue: 0/75/0/0 (size/max/drops/flushes); Total ||output drops: 0 ||| ||| Queueing strategy: fifo ||| ||| Output queue: 0/40 (size/max) ||| ||| 5 minute input rate 2735000 bits/sec, 519 packets/sec ||| ||| 5 minute output rate 599000 bits/sec, 440 packets/sec ||| ||| 1744270788 packets input, 3129573151 bytes, 0 no buffer ||| ||| Received 61767996 broadcasts (0 multicast) ||| ||| 0 runts, 0 giants, 0 throttles ||| ||| 11288249 input errors, 11288249 CRC, 0 frame, 0 overrun, ||0 ignored ||| ||| 0 watchdog, 16264953 multicast, 0 pause input ||| ||| 0 input packets with dribble condition detected ||| ||| 1466543564 packets output, 2681409739 bytes, 0 underruns ||| ||| 0 output errors, 15260833 collisions, 1 interface resets ||| ||| 0 babbles, 6268873 late collision, 0 deferred ||| ||| 0 lost carrier, 0 no carrier, 0 PAUSE output ||| ||| 0 output buffer failures, 0 output buffers swapped out ||| ||| ||| ||| ||| |||_______________________________________________ |||cisco-nsp mailing list [email protected] |||https://puck.nether.net/mailman/listinfo/cisco-nsp |||archive at http://puck.nether.net/pipermail/cisco-nsp/ ||| || | _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
