Hi folks... I'm trying to bring up a pair of new OSPF connections and can't figure this out.. we do these connections all the time so scratching my head....
Cisco 1811 at customer site connected via 2 ethernet connections (bridged DSL) back to 6500 switches here (each VLAN goes to a switch). This is a pretty typical setup for us, except this one doesn't work for some reason.... 1811 Config: interface FastEthernet0 description VLAN205 ip address xx.xx.xx.26 255.255.255.248 speed 100 full-duplex ! interface FastEthernet1 description VLAN206 ip address xx.xx.xx.162 255.255.255.248 speed 100 full-duplex interface Loopback0 description OSPF Loopback ip address xxx.xxx.xxx.5 255.255.255.255 router ospf 1 router-id xx.xx.xx.5 log-adjacency-changes redistribute connected subnets network xx.xx.xx.24 0.0.0.7 area 0 network xx.xx.xx.160 0.0.0.7 area 0 6500 Configs: interface Vlan205 description xxxxxxxxxxxxxxx ip address xx.xx.xx.25 255.255.255.248 router ospf 1 router-id xx.xx.xx.161 log-adjacency-changes redistribute connected subnets redistribute static subnets network xx.xx.xx.24 0.0.0.7 area 0 ----------- interface Vlan206 description xxxxxxxxxxxxxxxxxx ip address xx.xx.xx.161 255.255.255.248 router ospf 1 log-adjacency-changes redistribute connected subnets redistribute static subnets network xx.xx.xx.160 0.0.0.7 area 0 There is no problem pinging across both interfaces etc..... but OSPF will not come up at all.... Ideas? Thanks in advance! Paul _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
