Hello, I'm having an issue getting PBR to work properly when I try to do both source and destination routing. I have the following config:
interface FastEthernet1/0.103 ip policy route-map client-outbound access-list 13 permit 1.1.1.1 0.0.0.15 access-list 14 permit 2.2.2.2 0.0.0.15 route-map client-outbound permit 10 match ip address 13 set ip next-hop 4.4.4.4 This works, when enabled all traffic originating from 1.1.1.1/28 gets routed to the correct place. But I want to say that any traffic coming from 1.1.1.1/28 going to 2.2.2.2/28 goto next-hop 5.5.5.5. If I add a line of: route-map client-outbound permit 5 match ip address 14 set ip next-hop 5.5.5.5 Traffic is not matched and all traffic continues to go out rule #10. I also tried: route-map client-outbound deny 5 match ip address 14 And this doesn't help either. Any suggestions? This is running on 12.4(5a) on a 7206/400. Thanks in advance for any pointers. Jeremy _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
