Hi, You have to tunnel STP/VTP/CDP because these protocols use well known MAC addresses and when arrive to a switch must be processed by this switch. If this is the case for LLDP then tunnelling must be used, if not, cisco switch will then happily forward it without any processing, LLDP uses L2 multicast MAC address 01:80:c2:00:00:0e.
After some research I could see that in 12.2(37)SE LLDP is enabled by default and Layer 2 protocol tunnelling for LLDP is not supported. Looks like you are out of luck on this one. Regards, Jeff > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:cisco-nsp- > [EMAIL PROTECTED] On Behalf Of Uwe Sauerland > Sent: donderdag 9 augustus 2007 13:05 > To: [email protected] > Subject: [c-nsp] HP/Cisco LLDP/CDP > > Hello, > > we want to provide dot1q-tunnel/l2-tunnel service based on 3560 for a > customer. > > The customer end-devices are HP ProCurve switches. > > l2-tunnel on Cisco supports STP/VTP/CDP, but no LLDP (I found no other > indication so far), and unfortunately the customer wants to use LLDP for > his > management software (I guess the ProCurve management tool). > > Any idea/experience in how to fulfil this requirement? > > Thanks! > > Uwe > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
