-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Everton da Silva Marques wrote: > On Thu, Aug 16, 2007 at 06:14:32PM +0300, [EMAIL PROTECTED] wrote: >> I want to establish a connexion between the ?? Serial interface 1 ?? >> and ?? the ethernet interface 1 ??, its must be inside the same >> pool address (for e.g /30 netmask). For this, the router in the >> middle must be really transparent (bridge). >> >> Is it possible to establish this link ? If yes, could someone >> help us for the configuration ? > > Search for the following commands: > > interface Ethernet1 > bridge-group 2 > ! > interface Serial1 > bridge-group 2 > ! > bridge 2 protocol ieee
And you would need to add "no ip routing". Of course, it wasn't clear from his initial email if the serial interface was on device and the ethernet was on the other. In that case, you have an issue because you have different encaps on each end of the link. - -- ========= bep -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.4 (MingW32) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFGxKcSE1XcgMgrtyYRAkIDAJ9qKnco7DgCdvp/zP8gI/Gzd1TpXgCguPQl GAdiuRxYz3xJ9zdI4BvUZTA= =xATs -----END PGP SIGNATURE----- _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
