Dear all, We are setting up tunnels within our network, and are using some previous documented configurations for this. We will use this to enable virtual P2P BGP sessions to isolate certain parts of our routing table. Cheap, temporary, and fast.
interface Tunnel0 ip address 192.168.100.9 255.255.255.252 no ip unreachables no ip proxy-arp ip mtu 1524 tunnel source Loopback1 tunnel destination 10.10.10.10 Is there any information/advice/rule-of-thumb on setting the MTU size on the tunnel interface? Thanks in advance, -nick/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
