Did you use a cross-over cable? Michael
> Message: 1 > Date: Wed, 24 Oct 2007 06:50:05 -0400 > From: "Paul Stewart" <[EMAIL PROTECTED]> > Subject: Re: [c-nsp] Ethernet Question - Problem with link > To: "'Mike Louis'" <[EMAIL PROTECTED]>, "'Pete Templin'" > <[EMAIL PROTECTED]> > Cc: [email protected] > Message-ID: <[EMAIL PROTECTED]> > Content-Type: text/plain; charset="us-ascii" > > Thanks - yes VLAN exists and no changes to VLAN database > recently other than > adding this new VLAN.... it's on an access port which is > trunked out on > another port... > > Paul > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Mike Louis > Sent: Wednesday, October 24, 2007 12:42 AM > To: Pete Templin > Cc: [email protected] > Subject: Re: [c-nsp] Ethernet Question - Problem with link > > Is there vlan configured on the up down switch port? Does > that vlan exist in > the database. > > > If you recently removed a vlan database from a switch and a > vlan configured > on the switchport doesn't exist in the DB you will see this issue. > > > > ________________________________________ > From: [EMAIL PROTECTED] > [EMAIL PROTECTED] > On Behalf Of Steve Bertrand [EMAIL PROTECTED] > Sent: Tuesday, October 23, 2007 10:50 PM > To: Pete Templin > Cc: [email protected] > Subject: Re: [c-nsp] Ethernet Question - Problem with link > > Pete Templin wrote: > > Paul Stewart wrote: > > > >> Just looking for a thought - ethernet cable from switch to > switch. One > side > >> is up/up but other side is up/down.... > >> > >> Cabling problem? It's a new connection... > > > > The problem(s) could be: > > > > 1: Transmitter on up/up side. > > 2: Cabling problem. > > 3: Receiver on up/down side. > > 4: Perhaps other settings issues. > > > > The easy one is #2. > > (My last message bounced, wrong address I used): > > I'd go with #4. I find settings easier to check rather than physical, > especially if accessible remotely when possible. > > Could be misconfig, or the port was forgotten about and was > earlier used > as a span monitor port and would show up/down. This is > happening on the > 6500, right? > > Steve _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
