Peter Rathlev wrote: > I hope you did this in a lab or something similar. :-) The "desktop > vlan" is not intended for routing, as in "show sdm prefer vlan | incl > unicast IPv4" gives you a clear "0". The 3550 simply wouldn't allow any > routing with that template. The 3560 appears to process switch instead > then. But why change the SDM template away from the "desktop access" > default setting in the first place? >
Unfortunately not. :-( I know that this profile is not intended for routing. It was set to "desktop vlan" because someone else - who normally configures our layer2 devices - had done the first configuration. And I just had forgotten about this setting (By the way why doesn't the sdm setting shows up in den running-configuration?) while doing the final configuration and putting the device in service. Regards Mark _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
