Exactly, Eric. I've tested in another switch and works. But this, not. The model is Cisco Catalyst 2960G - 12.2(25)FX and after start the service, the switch give me these informations:
02:42:44: %GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port 65560 has bad crc 02:42:44: %PHY-4-UNSUPPORTED_TRANSCEIVER: Unsupported transceiver found in Gi0/24 =========================== Port Name Status Vlan Duplex Speed Type Gi0/21 notconnect 1 auto auto unsupported =========================== #show controllers ethernet-controller gi0/21 phy GigabitEthernet0/21 (gpn: 21, port-number: 21) ----------------------------------------------------------- General SFP Information ----------------------------------------------- Identifier : 0x03 Connector : 0x07 Transceiver : 0x00 0x00 0x00 0x02 0x12 0x10 0x01 0x05 Encoding : 0x01 BR_Nominal : 0x15 Vendor Name : FINISAR CORP. Vendor Part Number : FTRJ1319P1BTL Vendor Revision : 0x41 0x20 0x20 0x20 Vendor Serial Number : P6325H6 ----------------------------------------------- Other Information ------------------------------------------------------- Port asic num : 2 Port asic port num : 3 XCVR init completed : 1 Embedded PHY : not present SFP presence index : 0 SFP iter cnt : 80919 SFP failed oper flag : 0x0 IIC error cnt : 0 IIC error dsb cnt : 0 IIC max sts cnt : 4 Chk for link status : 1 Link Status : 0 Link Status Media : 0 Preferred media : 1 Resolved Media : 0 Config Media : 0 Access Count : 0 Access Count Max : 2 Port Rx Loss : yes Port Tx Fault : no Port Tx Disable : no -----Original Message----- From: Eric Van Tol [mailto:[EMAIL PROTECTED] Sent: sexta-feira, 11 de janeiro de 2008 11:53 To: Dan Sabau; [EMAIL PROTECTED] Cc: [email protected] Subject: RE: [c-nsp] GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Dan Sabau > Sent: Friday, January 11, 2008 6:36 AM > To: [EMAIL PROTECTED] > Cc: [email protected] > Subject: Re: [c-nsp] GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR > > use: > service unsupported-transceiver > > just paste it in conf t, you won't find it with the question mark. > > Unfortunately, I don't believe this command works across all platforms or with all types of "unsupported" SFPs. I just discovered this command last night after posting to another list and tried it today with a Finisar SFP on an ME3400-12CS and no dice. The switch takes the command, but still shows 'unsupported' and the link doesn't come up. :-( -evt _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
