Why do you need bfd on a serial interface? Seems like a waste of CPU and BW.
On Feb 4, 2008 1:12 PM, Luan Nguyen <[EMAIL PROTECTED]> wrote: > I have bgp running between PE and CE. > So on the PE, you do: > router bgp xxxx > address-family ipv4 vrf whatever > neighbor y.y.y.y fall-over bfd > Do the same for the CE under bgp. > Then on the link between CE and PE, configured the bfd interval...etc. > That > should work. > > The problem is my CE is a 1841 with a Channelized T1/PRI port and even > with > the latest 12.4.15T3, i can't put the bfd command under the serial > interface! Without interface level bfd command, bfd won't work. Hello? > I did try with an ethernet link between PE and CE, and bfd config looks > good. > > -lmn > > > On Feb 4, 2008 11:47 AM, Vikas Sharma <[EMAIL PROTECTED]> wrote: > > > Hi, > > > > Anyone have configured VRF aware BFD? If yes pls let me know how? > > > > Regards > > Vikas Sharma > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
