Dmitry, You are most likely hitting CSCsd45386 "write mem generates error % String too long to write to nvram"
Symptoms: When you enter the write memory command, the following error message and a traceback are generated: Router#wr Building configuration... % String too long to write to nvram (2578):Compressed configuration from 3452120 bytes to 786685 bytes[OK] Uncompressed configuration from 786685 bytes to 3452120 bytes Conditions: This symptom is observed on a Cisco router when the configuration is saved after you have entered the parser config cache interface command. Workaround: Disable the no parser config cache interface command. It is fixed in the current versions of 12.2SB, 12.4 and 12.4T trains. Arie -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dmitry Kiselev Sent: Monday, February 18, 2008 11:20 AM To: [email protected] Subject: Re: [c-nsp] "sh run" bug Hello! On Mon, Feb 18, 2008 at 11:13:35AM +0200, Dmitry Kiselev wrote: In few minutes I fix problem by myself by disabling IOS parser interfaces cache. Sorry for my noise in the list. :( Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#no parser config cache interface Router(config)#end Router#clear parser cache Clearing parser cache... Router#sh run interface GigabitEthernet0/1.101 Building configuration... Current configuration : 2101 bytes ! interface GigabitEthernet0/1.101 encapsulation dot1Q 101 ip address X.X.X.1 255.255.255.0 ... > Hello! > > Does anybody see such problems with running configuration building? > Subject router is 7200-NPE-G1 under 12.2(25)S14, uptime about 17 weeks. > Contact TAC? No other solutions? > > > Router#sh run > % String too long to write to nvram (2098): > Current configuration : 124735 bytes > ! > ! Last configuration change at 01:08:53 EET Mon Feb 18 2008 ! NVRAM > config last updated at 01:08:53 EET Mon Feb 18 2008 ! > version 12.2 > parser config cache interface > ... > > Router#sh run interface GigabitEthernet0/1.101 Building > configuration... > > % String too long to write to nvram (2098): > Current configuration : 5 bytes > end > > Router# > Router#sh startup-config | beg interface_GigabitEthernet0/1.101 > interface GigabitEthernet0/1.101 encapsulation dot1Q 101 ip address > X.X.X.1 255.255.255.0 ... > > Router#copy run start > Building configuration... > > % String too long to write to nvram (2098):[OK] Router#sh > startup-config | beg interface_GigabitEthernet0/1.101 Router# -- Dmitry Kiselev _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
