> [mailto:[EMAIL PROTECTED] On Behalf Of Felix Nkansah > > This is to provide more info towards helping me solve the problem. > > When I do "show power inline" in the module, I get the output > below in the > first lines. > > Module Available Used Remaining > (Watts) (Watts) (Watts) > ------ --------- -------- --------- > 1 n/a n/a n/a >
Do a 'show power inline' from the router, you should see the following: PowerSupply SlotNum. Maximum Allocated Status ----------- -------- ------- --------- ------ INT-PS 0 240.000 24.400 PS GOOD Interface Config Device Powered PowerAllocated --------- ------ ------ ------- -------------- Gi1/0 auto Unknown On 24.400 Watts Big beef; if you do not have a module that uses inline power, there is no way to determine whether you have an AC-IP power supply (the show command isn't available). Next big item, undocumented and took the TAC over an hour to figure out, you must permit VLAN 1 (and I think CDP?) on the trunk to the internal switch for power to work. Hope that helps. Josh _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
