Antonio,
Thanks for the reply. I understand that those values are not
recommended and in fact i do not use them outside of the lab. I am,
however, struggling to understand how TCP reacts to very very low burst
levels. What mechanism is causing such low throughput as the
tcp_receive_window values are not low?
Christopher Hunt
Antonio Querubin wrote:
On Thu, 19 Jun 2008, Christopher Hunt wrote:
Sorry,
The rate-limit statement that results in 0.2mbps throughput is:
rate-limit input 10000000 5000 5000 conform-action transmit
exceed-action drop
Those burst values appear to be far below the recommended values for
most cases. See the following:
http://www.cisco.com/en/US/docs/ios/12_2/qos/command/reference/qrfcmd8.html
In your case, if your target rate-limit is 10000000, then 1875000 and
3750000 are what you probably should be using for the burst.
Antonio Querubin
whois: AQ7-ARIN
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
