Adam, I think you have a bit too many routes on this box...
Take a look at http://www.cisco.com/en/US/docs/ios/ipswitch/command/reference/isw_i1.ht ml#wp1014315 The thing is that mls cef maximum-routes is not supported on Sup2... Can you please share the outputs of: - show ip route summary - show mls cef summary - show mls cef maximum-routes Arie -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Adam Korab Sent: Wednesday, August 27, 2008 17:58 PM To: [email protected] Subject: [c-nsp] 6506 unusual behavior Hi, I could use some advice here. 6506 with single WS-X6K-SUP2-2GE. Just changed IOS from 122(18)SXF14. to 12.2(18)SXF14 to get around a nasty bug that presented as hanging things like "sh run" and "dir disk0"...as well as passing traffic out the wrong interface. Now there's what appears to be an ssh debug message upon every CLI logout: edge1#exit channel_by_id: 0: bad id: channel free client_input_channel_req: channel 0: unknown channel Connection to edge1.xxx.xxx closed. And secondly, on the same box, can somebody point me in the right direction regarding this? 5d04h: %MLSCEF-SP-7-FIB_EXCEPTION: FIB TCAM exception for IPv4 unicast, Some routes will be software switched. Use "mls cef maximum-routes" to modify FIB TCAM partition. Thanks! --Adam _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
