You can check the config-register setting on SP by: rem comm sw sh ver | i register
SP is probably still set to 2142. You should change it to 0x2102 by going to config on RP. When you save the config it will be saved on SP also. After saving you can issue: rem comm sw sh ver | i register It should indicate 0x2102 aftrer reboot. Asad -------------- Original message -------------- From: "Brett Clausenhauf" <[EMAIL PROTECTED]> > Hey Guys.. > > I have a query I cannot seem to find any answer too. > > > When a sup720 module is booting, if you do a CTRL + Break into rommon & > change the confreg register on the SP module (Changed to confreg 0x2142 & > NOT the RP module, what does this actually do? I did this by mistake whilst > troubleshooting an issue. The issue is now resolved but I never got the > opportunity to put this back (Also not sure what to put it back too). The > module boots up the config & appears to be working 100 percent fine... I am > very concerned if doing this does anything detrimental that is going to be a > concern later. > > Can anybody who might know advise? It would be very much appreciated.. > > > Thanks in advance. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
