Hey Guys.. I have a query I cannot seem to find any answer too.
When a sup720 module is booting, if you do a CTRL + Break into rommon & change the confreg register on the SP module (Changed to confreg 0x2142 & NOT the RP module, what does this actually do? I did this by mistake whilst troubleshooting an issue. The issue is now resolved but I never got the opportunity to put this back (Also not sure what to put it back too). The module boots up the config & appears to be working 100 percent fine... I am very concerned if doing this does anything detrimental that is going to be a concern later. Can anybody who might know advise? It would be very much appreciated.. Thanks in advance. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
