Hi, thanks for that. Just had a look at my inventory sh inventory NAME: "slot 0", DESCR: "ISE 10G Modular Services Card v2" PID: 12000-SIP-601 , VID: V04, SN: SAD12340460
Looks like I have an ISE card installed. If I look at the restrictions for the ISE, seems like only the following cards are supported: IP Service Engine (ISE): –4-port Gigabit Ethernet ISE line card –4-port OC-3c/STM-1c POS/SDH ISE line card –8-port OC-3c/STM-1c POS/SDH ISE line card –16-port OC-3c/STM-1c POS/SDH ISE line card –4-port OC-12c/STM-4c POS/SDH ISE line card –1-port OC-48c/STM-16c POS/SDH ISE line card However it then goes to mention that the following cards support it. Engine 5 SPA Interface Processors (SIPs): –10G Engine 5 SPA Interface Processor (12000-SIP-600) –2.5G multiservice engine SPA Interface Processor (12000-SIP-401) –5G multiservice engine SPA Interface Processor (12000-SIP-501) –10G multiservice engine SPA Interface Processor (12000-SIP-601) The GE cards are installed in a 12000-SIP-601, or is that I don't have an'Engine 5' within the 601installed? Regards Mark ----- Original Message ---- From: Leonardo Gama Souza <[EMAIL PROTECTED]> To: Mark Tech <[EMAIL PROTECTED]> Cc: [email protected] Sent: Tuesday, September 16, 2008 3:49:54 PM Subject: RES: [c-nsp] Cisco 12406 Etherchannel There are some restrictions... Take a look: http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/lnkbndl.html Cheers. ________________________________ De: [EMAIL PROTECTED] em nome de Mark Tech Enviada: ter 16/9/2008 08:12 Para: [email protected] Assunto: [c-nsp] Cisco 12406 Etherchannel Hi I am trying to configure Ethernchannel/link bundling on a 12406. The port channel seems to be accepted, however when I try and add a channel-group to my GE interfaces, it says its not supported? I am using SPA-10X1GE-V2 line cards with c12kprp-p-mz.120-32.SY6.bin IOS interface Port-channel1 ip address x.x.x.x 255.255.255.252 no ip directed-broadcast channel-group minimum active 1 no channel-group bandwidth control-propagation router(config-if)#channel-group 1 Error: not supported on GigabitEthernet0/0/0. Is there a way to bundle more that 1GE port on a 12406? Regards Mark _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
