Hi there. 1. The time taken for show run is about 7-10 minutes long
2. #sh start Using 67275 out of 391160 bytes Can't really tell how much lines are there. It's a lot. 3. ROM: System Bootstrap, Version 12.1(11r)E1, RELEASE SOFTWARE (fc1) BOOTLDR: c6sup2_rp Software (c6sup2_rp-PS-M), Version 12.2(18)SXD4, RELEASE SOFTWARE (fc1) System image file is "sup-bootflash:c6k222-ps-mz.122-18.SXD4.bin" Using quite an old IOS I think. I just took over from the predecessor. /Jason -----Original Message----- From: Phil Mayers [mailto:[EMAIL PROTECTED] Sent: Tuesday, September 30, 2008 4:47 PM To: Jason Koh Cc: [email protected] Subject: Re: [c-nsp] Extremely slow performing show running-config Jason Koh wrote: > Hi there > > I have a strange problem with a pair of cat6509s. Both are connected to each > other via OSPF and IBGP, with EBGP with my upstream providers. > > Whenever I use show running-config, it will pause for an extremely long time > after the line "Building Configuration". It happens from either console or > telnet sessions. At first I thought it was a CPU or memory problem, but > "show proc cpu" and "show proc mem" shows nothing out of the ordinary (cpu > less than 20% and memory with more than 256M free). Rebooting both machines > doesn't solve the problem either. > > After further investigations, I found out that the same problem occurs when > I do the following as well. > > 1) copy running-config startup-config > 2) write memory > > Show startup-config does not have this problem. Some questions: 1. How long is "extremely long" 2. How big (in lines and in bytes) is your startup config 3. Which SUP, IOS version and linecards are you using _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
