Hi folks,
In a nutshell, I have an ISP who has LNS' terminating L2TP tunnels from the
incumbent telco. These L2TP tunnels are terminated based on domain as is
common and we have three terminating vpdn-group (two production, one testing).
Each vpdn-group uses the same virtual template ('virtual-template 1') and this
template in turn has a hard coded 'ip wccp x redirect in' (where x is the
configured wccp service id. We'll use 97.
So the watered down config is:
vpdn-group 1
accept-dialin
protocol l2tp
virtual-template 1
...
vpdn-group 2
accept-dialin
protocol l2tp
virtual-template 1
...
...
interface Virtual-Template1
ip unnumbered Loopback0
ip access-group cust-in in
ip wccp 97 redirect in
...
What I need to do is to be able to selectively use 'ip wccp 97 redirect in' by
RADIUS attribute but I can't seem to find the right (any) RADIUS attributes.
I think there may be two ways of doing it but I don't know if any / either are
possible:
1) have RADIUS specify a 'virtual-template 2' rather than 1 dynamically where
I don't have the 'ip wccp 97 redirect in' statement;
2) have RADIUS specify an attribute that can add the 'ip wccp 97 redirect in'
statement dynamically.
Any help / advice would be much appreciated.
Kind regards,
Barry O'Donovan
http://www.opensolutions.ie/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
