sorry as both sites have different networks so you can't use this technology
On Tue, Feb 24, 2009 at 9:54 AM, Ibrahim Abo Zaid <[email protected] > wrote: > Hi Rocker > > that doesn't seem to me as MPLS VPN topology as both PE1 interfaces to CE1 > and CEZ are non-MPLS interfaces , it is much like > local-switching scenario > > try using CONNECT command > > > > best regards > --Ibrahim > > On Tue, Feb 24, 2009 at 2:11 AM, Rocker Feller < > [email protected]> wrote: > >> Hi, >> >> My full scenario >> >> CE1 -------> PE1 -----------> PE2 -------------> CEZ >> >> On the PE1 interface I have a tunnel to CEZ . >> >> nb: PE2 is not mpls enabled. >> >> CEZ has a ptp link to PE2 >> >> LSP - tunnel is up from PE1---> CEZ and I can reach the CEZ router via >> the >> tunnel ptp. >> >> - from the CEZ lan CE1 lan is reacheable. >> >> It is only from the CE1 router and from the PE1 that I cannot reach CEZ >> lan. >> >> Please note this customer has 6 other branches which are working well. >> >> Thanks >> >> >> >> On Tue, Feb 24, 2009 at 1:11 AM, schilling <[email protected]> >> wrote: >> >> > check no ip unreachable on the PE interface? I got bite once. >> > >> > verify the LSP? >> > >> > Ivan's blog for rescue :-) >> > >> > http://wiki.nil.com/PE-to-PE_troubleshooting_in_MPLS_VPN_networks >> > >> > >> > Schilling >> > >> > On Mon, Feb 23, 2009 at 4:51 PM, Rocker Feller < >> > [email protected]> wrote: >> > >> >> Hi, >> >> >> >> I work in an ISP environment and in it I found developed MPLS >> delivering >> >> ip >> >> vpns. >> >> >> >> There is one client with 5 branches. >> >> >> >> All work fine except for 1. >> >> >> >> This is the scenario. >> >> >> >> The default route is derived from the corporate office (HQ). Its >> network >> >> range is 172.16.0.0/16 >> >> >> >> Say branch with problem is branch Z ip range is 172.16.7.0/24 >> >> >> >> >From Z Lan I can ping HQ Lan ok >> >> >> >> ping 172.16.1.1 source 172.16.7.1 >> >> >> >> Type escape sequence to abort. >> >> Sending 5, 100-byte ICMP Echos to 172.16.1.1, timeout is 2 seconds: >> >> Packet sent with a source address of 172.16.7.1 >> >> !!!!! >> >> Success rate is 100 percent (5/5), round-trip min/avg/max = 24/29/36 ms >> >> >> >> >From HQ I cannot ping Z apart from reaching the Z router.the lan >> >> >> >> ping 172.16.7.1 >> >> PING 172.16.7.1 (172.16.7.1) 56(84) bytes of data. >> >> 64 bytes from 172.16.7.1: icmp_seq=0 ttl=253 time=19.8 ms >> >> >> >> Any other connections are dropped from branch Z router >> >> >> >> A trace reveals packets are dropped from the main MPLS PE router. >> >> >> >> The PE router can reach the CE router but not any pc behind it. >> >> >> >> >> >> Your input appreciated >> >> >> >> >> >> Regards >> >> Rocker >> >> _______________________________________________ >> >> cisco-nsp mailing list [email protected] >> >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> >> >> > >> > >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
