Hi,
does anybody know how load-balancing in an etherchannel works on a "4
Port ISE Gigabit Ethernet" for Cisco 12000 in detail?
I have the following problem: I configured an etherchannel consisting of
two GigabitEthernet ports on the same linecard. Only one port is
utilized (see show command below). There is no inbound traffic and the
outbound traffic originates from various prefixes to basically 3 prefixes.
I have a cisco 12010/PRP with IOS 12.0(31)S6.
sh interfaces port-channel 1 load
ID bits/sec pack/sec
---------- ------------ ----------
PortCh1 Tx 149655000 24926
Rx 0 0
Members (%) bits/sec pack/sec
---------- --- ------------ ----------
Gi1/0 Tx 99 149643000 24919
Rx 54 0 0
Gi1/1 Tx 1 11000 8
Rx 46 0 0
The configuration is:
interface Port-channel1
bandwidth 2000000
ip address x.x.x.x 255.255.255.252
ip access-group 188 in
ip access-group 189 out
no ip redirects
no ip unreachables
no ip directed-broadcast
no ip proxy-arp
ip route-cache flow sampled
load-interval 30
channel-group minimum active 1
no channel-group bandwidth control-propagation
interface GigabitEthernet1/0
no negotiation auto
channel-group 1
no cdp enable
!
interface GigabitEthernet1/1
negotiation auto
channel-group 1
no cdp enable
Is there a fundamental problem with this scenario?
Thanks,
Jan
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
