Setup is as follows; 2 edge routers, each with a BGP session receiving full
routes to the same provider router. The provider is load balancing inbound
traffic to our AS nicely, 50/50 between the edge routers.. I would also like
to load balance the outbound traffic.. I've considered adding 'maximum-paths
2' to install the two equal paths, but an concerned about FIB TCAM impacts.
Will adding this command cause each equal cost route to take one additional
TCAM entry, i.e. full routing table x 2 > 524k TCAM limit = EPIC meltdown?
Current FIB TCAM:
L3 Forwarding Resources
FIB TCAM usage: Total Used
%Used
72 bits (IPv4, MPLS, EoM) 524288 285506
54%
144 bits (IP mcast, IPv6) 262144 5
1%
Peter Kranz
<http://www.UnwiredLtd.com> www.UnwiredLtd.com
Desk: 510-868-1614 x100
Mobile: 510-207-0000
<mailto:[email protected]> [email protected]
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
