Hello Ivan,
Thank you for your response.
In my design, I am load sharing the traffic by multihomed BGP with two ISPs
through two local 7600 routers. To avoid any single point of failure, we
have a backup link for each ISP connected to each local router. as below:
Router1 connected with primary link of ISP1 and backup link of ISP2.
Router2 connected with primary link of ISP2 and backup link of ISP1
I only receive default-route from each ISP (primary bgp peer has higher
local preference on each router).
my network is divided into two subnets (x.x.32.0/20 & x.x.48.0/20)
normally, x.x.32.0/20 go through Router1 & ISP1, and x.x.48.0/20 go through
Router2 & ISP2 incoming and outgoing.
what I need is, once the primary BGP peer of ISP1 on Router1 goes down, the
subnet x.x.32.0/20 go to backup link on Router2 which is already has a
preferred default route from ISP2 serving the subnet x.x.48.0/20. The same
case should be applied vice versa.
load sharing for incoming traffic is working properly, but my problem is
with outgoing traffic since I am only receiving default-route from each ISP!
I know it is a bit complicated but I hope you can give me some help.
Thank you,
Manaf
--------------------------------------------------
From: "Ivan Pepelnjak" <[email protected]>
Sent: Thursday, August 13, 2009 10:31 PM
To: "'Manaf Al Oqlah'" <[email protected]>; <[email protected]>
Subject: RE: [c-nsp] Event Manager question
Absolutely, with EEM 3.0 an applet can be triggered with an SNMP trap or
inform. The details are here (although the article describes a slightly
different task):
http://wiki.nil.com/Trigger_EEM_applets_with_SNMP_Informs
However, are you absolutely positive there is no other way to get what you
need? In many cases you could use a smart routing design instead of the
PBR.
Ivan
http://www.ioshints.info/about
http://blog.ioshints.info/
-----Original Message-----
From: Manaf Al Oqlah [mailto:[email protected]]
Sent: Thursday, August 13, 2009 4:31 PM
To: [email protected]
Subject: [c-nsp] Event Manager question
Hi all,
Can I configure event manager to be started when it gets
notification from another router. for example, I want router1
to be configured with policy based routing on a specific
interface once the bgp peer on router2 is down. I don't want
to permanently configure the PBR since it is consume very
high CPU utilizing on router1
Thank you,
Manaf
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
