Ah-ha! I found the solution to my first inquire - traffic shapping on SVIs. Apparently the key was "mls qos vlan-based" on the actual LAN interface. Now its adhering both input and output. I'll see if I can tweak to fit a dot1q subint.
On 8/18/09 8:52 PM, "Graham Wooden" <[email protected]> wrote: > Oh, the fun. I am not making much headway with this. After reading the Qos on > the PFC, I am even more lost. I can't seem to do any traffic shaping within > the map. I can't do the police cir, bandwidth percentage, etc. > Does anyone have any good working examples? > > > class-map match-any VOIP > match access-group 100 > ! > policy-map EdgeMap > class VOIP > police cir percent 25 > conform-action transmit > class class-default > police cir percent 75 > conform-action transmit > exceed-action drop > ! > access-list 100 permit udp any any gt 10000 > access-list 100 permit udp any any lt 20000 > access-list 100 permit udp any any gt 4000 > access-list 100 permit udp any any lt 6000 > > interface FastEthernet3/1.284 > bandwidth 20000 > encapsulation dot1Q 284 > ip address nn.nn.nn.nn 255.255.255.252 > end > > > edge01#conf t > Enter configuration commands, one per line. End with CNTL/Z. > > edge01(config)#interface fastEthernet 3/1.284 > edge01(config-subif)#service-policy input EdgeMap > police percent command is not supported in input direction for this interface > Configuration failed! > > edge01(config-subif)#service-policy output EdgeMap > police percent command is not supported in output direction for this interface > Configuration failed! > edge01(config-subif)# > > > > On 8/18/09 5:54 PM, "Graham Wooden" <[email protected]> wrote: > >> Hi there, >> >> I need to implement some traffic shaping on some SVI VLAN interfaces (a >> customer either with 1 server or 10 servers) on a 6509/Sup32. >> Running IOS is advipservicesk9_wan-mz.122-33.SXI1. >> >> I have currently setup some policy-maps that do some policing, which are >> feed by class-maps with match any. >> >> Seems like "service-policy output ..." works, but input doesn't. >> What is the best way to handle both ingress/egress traffic shaping? >> Do I need to input on the fastEthernet linecard? >> >> Thanks for any assistance or guidance. >> -graham >> >> >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
