Atif, What is your ios version? Hash Sent from my BlackBerry® wireless device from Aljawal
-----Original Message----- From: Atif Sid <[email protected]> Date: Thu, 20 Aug 2009 12:55:39 To: <[email protected]> Subject: [c-nsp] xconnect on VLAN interface ES card I have seen posts on this topic but still not clear.. currentl have WS line cards, with SUP-32 on 7606; PW on VLAN interface do not work. testing ES card customer facing, RSP-720 core facing, here is the issue.. any help will be great ! Is it possible to configure xconnect from an SVI interface, when your core facing cards are RSP-720? I have configured it: interface Vlan290 no ip address xconnect 10.10.136.129 37123712 encapsulation mpls end It does not come up: PE4#sh mpl l2transport vc Local intf Local circuit Dest address VC ID Status ------------- -------------------------- --------------- ---------- ---------- Vl290 Eth VLAN 290 10.10.136.129 37123712 DOWN PE4#sh mpl l2transport vc 37123712 det PE4#sh mpl l2transport vc 37123712 detail Local interface: Vl290 up, line protocol up, Eth VLAN 290 up Interworking type is Ethernet Destination address: 10.10.136.129, VC ID: 37123712, VC status: down Output interface: none, imposed label stack {} Preferred path: not configured Default path: no route No adjacency Create time: 00:00:49, last status change time: 00:00:03 Signaling protocol: LDP, peer 10.10.136.129:0 up Targeted Hello: 10.10.136.131(LDP Id) -> 10.10.136.129 Status TLV support (local/remote) : enabled/not supported Label/status state machine : remote ready, LndRru Last local dataplane status rcvd: no fault Last local SSS circuit status rcvd: AC DOWN(rx,tx faults) Last local SSS circuit status sent: no fault Last local LDP TLV status sent: no fault (withdrawn) Last remote LDP TLV status rcvd: not sent MPLS VC labels: local unassigned, remote 340 Group ID: local unknown, remote 0 MTU: local unknown, remote 1500 Remote interface description: ** Test PW with PE4 ES SVI int ** Sequencing: receive disabled, send disabled VC statistics: packet totals: receive 0, send 0 byte totals: receive 0, send 0 packet drops: receive 0, seq error 0, send 0 Although when I use a physical interface it comes up? RSP720 does not support it?? moved it to physical interface it comes up: interface GigabitEthernet2/1 no ip address ip verify unicast source reachable-via any load-interval 30 speed 1000 xconnect 10.10.136.129 37123712 encapsulation mpls end PE4#sh mpls l2transport vc Local intf Local circuit Dest address VC ID Status ------------- -------------------------- --------------- ---------- ---------- Gi2/1 Ethernet 10.10.136.129 37123712 UP _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
