Hey All, I'm new to all this voice stuff... We've just installed a AS5400 and plugged the PRI's in but I'm not seeing the interfaces below show up in the config. Eg: interface Serial6/0:15 interface Serial6/1:15 interface Serial6/2:15 interface Serial6/3:15
The Carrier is seeing alarms on their end so it could be that the PRI's aren't properly activated yet. But regardless of this, am I suppose to see those serial interfaces present in the config irrespective of whether the PRIs are up or not? When I try to manually add in the interface, it's not recognized. as1-ks(config)#interface serial 6/0:15? % Unrecognized command Some more details about the AS... as1-ks#sh ver Cisco IOS Software, 5400 Software (C5400-IS-M), Version 12.4(11)T, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2006 by Cisco Systems, Inc. Compiled Sun 19-Nov-06 00:33 by prod_rel_team ROM: System Bootstrap, Version 12.1(2r)XD1, RELEASE SOFTWARE (fc1) BOOTLDR: 5400 Software (C5400-BOOT-M), Version 12.1(5)T5, RELEASE SOFTWARE (fc1) as1-ks-mel uptime is 40 minutes System returned to ROM by reload at 15:53:14 AEST Tue Sep 29 2009 System restarted at 15:54:03 AEST Tue Sep 29 2009 System image file is "flash:c5400-is-mz.124-11.T.bin" Cisco AS5400 (R7K) processor (revision T) with 262144K/65536K bytes of memory. Processor board ID JAB042904CY R7000 CPU at 250MHz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache Last reset from IOS reload Manufacture Cookie Info: EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x31, Board Hardware Version 3.27, Item Number 800-5171-01, Board Revision B0, Serial Number JAB042904CY, PLD/ISP Version 2.2, Manufacture Date 11-Jul-2000. Processor 0x14, MAC Address 0001.42b3.5b7e Backplane HW Revision 1.0, Flash Type 5V 2 FastEthernet interfaces 10 Serial interfaces 216 terminal lines 16 Channelized E1/PRI ports 512K bytes of NVRAM. 32768K bytes of processor board System flash (Read/Write) 8192K bytes of processor board Boot flash (Read/Write) Configuration register is 0x2102 as1-ks#sh controllers e1 6/2 E1 6/2 is down. Applique type is Channelized E1 - balanced Far End Block Errors Detected Receiver has loss of signal. alarm-trigger is not set Version info of slot 6: HW: 768, PLD Rev: 1 Framer Version: 0x8 Thanks. Andy This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. Please notify the sender immediately by email if you have received this email by mistake and delete this email from your system. Please note that any views or opinions presented in this email are solely those of the author and do not necessarily represent those of the organisation. Finally, the recipient should check this email and any attachments for the presence of viruses. The organisation accepts no liability for any damage caused by any virus transmitted by this email. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
