Hello
I have problem with xconnect on portchannel interface.
Portchannel is up and works correctly when configuration is:
interface Port-channel10
mtu 9216
no ip address
load-interval 30
storm-control broadcast level 2.00
storm-control multicast level 2.00
end
interface Port-channel10.508
no ip address
encapsulation dot1Q 508
xconnect 10.50.0.3 508 encapsulation mpls
end
waw-sw1#show mpls l2transport vc 508
Local intf Local circuit Dest address VC ID
Status
------------- -------------------------- --------------- ----------
----------
Po10.508 Eth VLAN 508 10.50.0.3 508 UP
waw-sw1#show interfaces description | inc Po10
Po10 up up
Po10.508 up up
but I want to do with untagged vlan:
waw-sw1#show running-config interface port-channel 10
Building configuration...
Current configuration : 211 bytes
!
interface Port-channel10
mtu 9216
no ip address
load-interval 30
storm-control broadcast level 2.00
storm-control multicast level 2.00
xconnect 10.50.0.3 508 encapsulation mpls
end
waw-sw1#show mpls l2transport vc 508
Local intf Local circuit Dest address VC ID
Status
------------- -------------------------- --------------- ----------
----------
Po10 Ethernet 10.50.0.3 508 UP
It's works only 2-3 minutes and after it portchannel change do state down.
Oct 16 15:07:00.404: %LINK-3-UPDOWN: Interface Port-channel10, changed
state to down
Oct 16 15:07:00.404: %XCONNECT-5-PW_STATUS: MPLS peer 10.50.0.3 vcid 508,
VC DOWN, VC state DOWN
Oct 16 15:07:02.599: %EC-SP-5-L3DONTBNDL2: Gi1/9 suspended: LACP currently
not enabled on the remote port.
Oct 16 15:07:08.500: %EC-SP-5-L3DONTBNDL2: Gi1/10 suspended: LACP
currently not enabled on the remote port.
Oct 16 15:07:11.440: %EC-SP-5-L3DONTBNDL2: Gi1/9 suspended: LACP currently
not enabled on the remote port.
How to do xconnect from untagged portchanel interface?
--
ŁT
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
