Tony, An easy trick is to insert a delay in your script that does the shut, and then after the delay to do the unshut. As there is no "wait" action in older EEM codes, you can use a trick with a ping that would never be answered, and a long timeout value.
event manager applet delay event syslog pattern "xxx" maxrun 630 action 1.0 cli command "ping 1.1.1.1 repeat 1 timeout 600" Does it work for you? Arie -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tony Varriale Sent: Tuesday, December 15, 2009 23:11 To: [email protected] Subject: [c-nsp] EEM BGP I've been having some issues with BGP peers dropping/flapping and tried to come up with a little EEM applet that would not only down a peer based on syslog entries but bring it back up. The bringing down part is easy and tested to work great. But I'm having a hard time with the bringing up part. Essentially I want to say, after x minutes, no shut the peer if you see the shut/BGP peer down/another arbitary message in the syslog. Any ideas? EEM 2.2 and/or 3.0 are fine. Thanks! tv _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
