Mikhail, Be sure both sce have the same pkg installed before you insert the second one to the sce. Which version are you running as it should be 3.6 and higher...
Jacob On Wed, Mar 3, 2010 at 5:17 PM, Arie Vayner (avayner) <[email protected]>wrote: > Mikhail, > > I recommend you open a TAC case, as this could be a hardware problem, > but it requires some debugging... > > Arie > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Mikhail Schedrin > Sent: Wednesday, March 03, 2010 11:46 > To: [email protected] > Subject: [c-nsp] SCE 8000 with 2*SCM-E > > Hi. > Does anybody have the experince of using SCE8000 with two SCM-E modules? > We > got the second SCM-E couple of days ago and SCE always boots in recovery > mode, when I install the second module. > I could not find any documentation about installing and configuring the > second SCM-E, I think it should work out of the box. Actually it does > not. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
