Hello,
I have a police-map applied to a vlan interface set to 10mbit. Works fine, as
long as traffic is routed on the CEF720 48 port module. But the moment traffic
is routed on the RSP720, traffic is above the 10mbit.
Is there something on the RSP720 that needs to enabled?
Here is my config:
policy-map 10Mbs
class class-default
police 10000000 1875000 3750000 conform-action transmit exceed-action drop
violate-action drop
interface Vlan123
bandwidth 10000
ip address x.x.x.x x.x.x.x
load-interval 30
service-policy input 10Mbs
service-policy output 10Mbs
interface GigabitEthernet1/0/0
switchport
switchport trunk allowed vlan 123
switchport mode trunk
mls qos vlan-based
mls qos trust dscp
Trunk port is on a SIP-600.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
