I've got a WS-C3560G-24TS switch doing L3. We are running multiple VLANs, each VLAN has it's own subnet, and the clients are getting their IP addresses from a MS DHCP server using ip helper-address command for each VLAN interface.
Problem: Setting up HP access points and controller. Want to use VLAN 3 as the native VLAN for the HP APs. Port that the AP is connected to is configured as the following: interface GigabitEthernet0/13 description Connect to HP AP switchport trunk encapsulation dot1q switchport trunk native vlan 3 switchport trunk allowed vlan 3,10,20,25,100 switchport mode trunk The controller is acting as the DHCP server, which is also on VLAN 3. But when the AP boots up, it takes a long time for it to get an IP address, and when it does finally get one, it's from a random VLAN of the listed allowed VLANs, and not from VLAN 3. I'm not sure if i'm missing something or if i'm just unable to use the native vlan command in this fashion. Any advice? Thanks. -- ---- ---- ---- ---- Chris Gotstein, Sr Network Engineer, UP Logon/Computer Connection UP http://uplogon.com | +1 906 774 4847 | [email protected] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
