Pshem, This is supported on 7600 with ES20/ES+/SIP modules (which are required for VPLS). Basically you can xconnect a SVI (either to VPLS or a point to point PW) and then configure different L3 features on it:
IP address and IP VRF ACLs PBR Routing protocols, OSPF, RIP, EIGRP,ISIS, BGP Netflow QoS Policing for SVI IP unnumbered Mcast routing, IGMP, PIM HSRP/VRRP/GLBP This can allow really interesting topologies with HSRP across the MPLS core etc. 7200 in general does not support VPLS. Arie -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Pshem Kowalczyk Sent: Friday, April 30, 2010 07:57 To: [email protected] Subject: [c-nsp] VPLS with L3VPN access Hi, I'm trying to get answer to the following question, and so far cisco website hasn't been very helpful (most probably because I don't know the cisco term for the feature). Is it possible on cisco software platforms (like 72xx) to configure a VPLS and somehow connect it to a L3VPN (on the same PE)? If not on the software ones - then what devices would support that? I'm not talking about mass deployment (1 or two AC per PE, handful of PEs). kind regards Pshem _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
