Hi all I'd like to know if is possible to achieve equal load balancing on 3560-E-TS switch. Basically I got 2 switches interconneted with 2 FE ports. 200Mbps is desirable throughput between themselves. IP routing enabled. CEF not enabled.
port channel is L2 trunk dot1q. I have 2 VRFs VLAN 100 - SW1 customer VRF1 VLAN 200 - SW1 and SW2 interconnection between swithces for VRF1 VLAN 300 - SW2 customer VRF1 VLAN 400 - SW1 customer 2 VRF2 VLAN 500 - SW1 and SW2 interconnection between swtiches for VRF2 VLAN 600 - SW2 customer 2 VRF2 over SVIs is running 2 OSPF processes for VRFs. Routing is fine. My issue is as follow: I can't achieve load balancing even I'm trying to setup src-ip, dst-ip etc. cisco describes examples but on CCIE blog guy is saying use same config on each end of etherchannel group otherwise won't work. I've speculated with all possible combination (hope :) but no success. Strange is that I'm using testers dedicated to generate traffic. VRF1 has full 100Mbps duplex VRF2 has follow: SW 1 side tester1 : TX-100Mbps RX-100Mbps SW 2 side tester2 : TX-100Mbps RX-50Mbps Can You please explain me where is 50Mbps? Hope these 50s are not in different VRF. Thanks a lot _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
