I'm not finding a lot of good options to do QoS for PPPoE over Ethernet (as opposed to ATM) subscribers. We have varying speeds for the subscribers ranging from 256k to 40m so I can't use a hard coded amount to reserve for voice. In addition, some customers have a single port ATA and some will have 6-10 lines on an IAD.
The setup has a single VLAN per DSLAM as a subinterface on a gig-E port in a 7200 VXR. Some of the newer equipment will obey 802.1p but the majority of our equipment does not. The authentication comes out of freeradius and the approximate downstream rate of each subscriber is recorded in the same table as the username/password so if I had to make static definitions for each speed tier I could do that. I don't need to do anything elaborate other than move any traffic to or from a specific subnet to the front of the queue. Thanks for any help Dave -- Dave Weis 515-224-9229 [email protected] http://www.internetsolver.com/ Please check out our Complete Support Service http://www.internetsolver.com/completesupport/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
