hi, i read on cisco's site that the default cos mapping for this receive queue is cos 5 mapped to priority queue 2, but when i do a show queuing im not seeing that mapping on the receive queue. when I try to map cos 5 to receive queue 2, I only have an option for queue id 1. On the outgoing queue all is fine but for the incoming queue I dont have what cisco says should be the default, cos 5 mapped to input queue 2.anyone know what the issue is? I also read somewhere that the incoming default queue mappings are enabled on a trunk interface only. interface FastEthernet1/15 load-interval 30 mls qos trust dscp hold-queue 100 in
Queueing Mode In Rx direction: mode-cos Receive queues [type = 1p1q0t]: Queue Id Scheduling Num of thresholds ----------------------------------------- 1 Standard 0 2 Priority 1 queue-limit ratios: 100[queue 1] 0[queue 2] queue thresh cos-map --------------------------------------- 1 1 0 1 2 3 4 5 6 7 2 1 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
