I believe it is card type command. config t#card type t3 0 3
On Thu, Sep 30, 2010 at 11:50 AM, Renelson Panosky <[email protected]>wrote: > I am configuring an ASR1006 with the following SPA cards installed. > > SPA-10X1GE-V2 > SPA-4XT3/E3 > SPA-8XCHT1/E1 > > Do anybody know the command to type to make the router recognize the > following cards ? > > SPA-4XT3/E3 > SPA-8XCHT1/E1 > > Because when i do sho ip int brief > > i only see the following > > Interface IP-Address OK? Method Status > Protocol > GigabitEthernet0/1/0 unassigned YES unset administratively down > down > GigabitEthernet0/1/1 unassigned YES unset administratively down > down > GigabitEthernet0/1/2 unassigned YES unset administratively down > down > GigabitEthernet0/1/3 unassigned YES unset administratively down > down > GigabitEthernet0/1/4 unassigned YES unset administratively down > down > GigabitEthernet0/1/5 unassigned YES unset administratively down > down > GigabitEthernet0/1/6 unassigned YES unset administratively down > down > GigabitEthernet0/1/7 unassigned YES unset administratively down > down > GigabitEthernet0/1/8 unassigned YES unset administratively down > down > GigabitEthernet0/1/9 unassigned YES unset administratively down > down > GigabitEthernet0 unassigned YES unset administratively down > down > > > However, when i do a sho log i can see them. Please help! > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
