In "show mpls l2transport vc 100 detail" do you see packet counters
(send/receive) incrementing on either side? What IOS version are you
running? Can you post the output from that command from each PE.
-Ben
On Oct 28, 2010, at 2:46 AM, Manaf Al Oqlah wrote:
Hi,
I have established an EoMPLS circuit on ME3750 switches as below.
everything seems to be working fine as my virtual circuit is UP
but my problem is that I cant ping IP address CE02 from CE01
PC01---CE01---PE01---PE02---CE02---PC02
I have applied the following configuration on PE01 & PE02 ES ports
interface loopback 0
ip address 1.1.1.1 255.255.255.255
!
interface GigabitEthernet1/1/1
description to PE02
ip address 10.0.0.1 255.255.255.252
mpls ip
!
interface GigabitEthernet1/1/2
description to CE01
switchport mode access
switchport access vlan 100
!
vlan 100
!
interface vlan 100
xconnect 2.2.2.2 100 encapsulation mpls
where could me my problem!
Regards,
Manaf Al Oqlah
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
