On Fri, Nov 12, 2010 at 12:40 PM, Brandon Ewing <[email protected]>wrote:
> On Fri, Nov 12, 2010 at 12:05:07PM -0500, Benjamin Lovell wrote:
> > Brandon,
> > Just as a side note, "show ip cef exact-route" will show you the software
> > CEF hash. It's not useful on hardware platforms to determine path
> selection
> > as hardware will not necessarily make the same decision. "show mls cef
> > exact-route" is what you want to use on these platforms. For distributed
> > forwarding(DFC) platforms it may need to be checked by attaching to the
> > ingress LC.
> >
> > -Ben
>
> show mls cef is not supported on 3560G, unfortunately. I'm going through
> my
> flowstats attempting to identify a specific flow through the port-channel
> that the switch says should use the indicated link, but am currently unable
> to locate one. Does anyone know the default CEF load-sharing algorithm on
> a
> 3560G?
>
Run this.
Rack1SW1#sh etherchannel load-balance
EtherChannel Load-Balancing Configuration:
src-mac
EtherChannel Load-Balancing Addresses Used Per-Protocol:
Non-IP: Source MAC address
IPv4: Source MAC address
IPv6: Source MAC address
Rack1SW1#
>
> --
> Brandon Ewing (
> [email protected])
>
> _______________________________________________
> cisco-nsp mailing list [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
