Do you manage the MUX's or are they managed by a carrier? What kind of link goes between the MUX's? Protection is usually implemented to prevent this type of scenario. Is it possible to just repair the link between the MUX's? If not, is it dark fiber? Can you just buy long range transceivers and run the ethernet link through the dark fiber? What protocol is running over the links? Can you just lower the timers? Others have suggested BFD, and IPSLA as options. Do you control the routers on both sides? There still isn't really enough information to suggest a solution.
On Sun, Nov 28, 2010 at 11:22 PM, jack daniels <[email protected]>wrote: > Router R1 --------------Ethernet > Cable-----MUX----------------MUX-----------Ethernet Cable-------Router > R2 > > I have backup link but conbvergence takes time and packet drops. The > area is remote area where I have this link , so link flaps are quite > normal. > I was thinking If links flaps 3 or 4 times in say 1 min , I put the > link in BAD state and not use it .Instaead I use backup link.If > prinary link is ok for 1 hr. I again use it... > > > > > > On Sun, Nov 28, 2010 at 12:04 AM, Keegan Holley > <[email protected]> wrote: > > Could you supply more info? What kind of link goes between the mux's? > What kind of mux's? Why can't you just fix the link? Is protection an > option? Can you run a second link for redundancy? > > > > Sent from my iPhone > > > > On Nov 27, 2010, at 1:03 PM, jack daniels <[email protected]> > wrote: > > > >> any comments Dear friends would be most appreciated and very helpfull > for me. > >> > >> On Sat, Nov 27, 2010 at 9:30 AM, jack daniels <[email protected]> > wrote: > >>> Hmm... laying intercity cables Technically good ....but not > >>> commercialy (which is most important).. :) > >>> > >>> On Sat, Nov 27, 2010 at 1:43 AM, Keegan Holley > >>> <[email protected]> wrote: > >>>> You can always get a really long cable so you don't need the MUX's. > >>>> > >>>> > >>>> On Fri, Nov 26, 2010 at 2:49 PM, jack daniels <[email protected] > > > >>>> wrote: > >>>>> > >>>>> Hi guys, > >>>>> > >>>>> I have a scenario > >>>>> > >>>>> > >>>>> Router R1 --------------Ethernet > >>>>> Cable-----MUX----------------MUX-----------Ethernet > Cable-------Router > >>>>> R2 > >>>>> > >>>>> > >>>>> my MUX to MUX link flaps a lot and my traffic impacts ....I have > >>>>> backup links also. Can I do something that when link MUX to MUX flaps > >>>>> I dont > >>>>> use this for some time , till it stablizes. > >>>>> > >>>>> Regards > >>>>> _______________________________________________ > >>>>> cisco-nsp mailing list [email protected] > >>>>> https://puck.nether.net/mailman/listinfo/cisco-nsp > >>>>> archive at http://puck.nether.net/pipermail/cisco-nsp/ > >>>>> > >>>> > >>>> > >>> > >> > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
