Have you tried it without the 'bridge irb'? It sounds like you want to bridge IP between the two sites and I think integrated routing & bridging is going to want to route IP..
Regards, Lee On 12/27/10, Joe Freeman <[email protected]> wrote: > I've got a situation where a customer is having to relocate from one > facility to another a few miles away. This customer has a 100Mb metro > ethernet connection at the old location, and can't get it moved for several > months. > > To help them out, we're trying to setup a pair of 3620's that we had with > wic-1dsu-t1's (4 ea router) to bridge the metro e across a multilink ppp > group and back to an ethernet connection at the new site. > > For some reason, I can't get this to work. Here's the config I'm using on > each side- > > bridge irb > bridge 1 protocol ieee > > int serial 0/0 > encaps ppp > multilink-group 1 > int serial 0/1 > encaps ppp > multilink-group 1 > int serial 1/0 > encaps ppp > multilink-group 1 > int serial 1/1 > encaps ppp > multilink-group 1 > > int multilink 1 > encaps ppp > bridge-group 1 > > int fa0/0 > bridge-group 1 > > > So I figure I'm either missing something simple, or something major, like > it's just not possible with this hardware. Either way, I'd appreciate > whatever thoughts anyone has. > > Thanks- > Joe > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
