I was doing some troubleshooting on my 2950g switch. The 'management
interface', is vlan1, and had an ip address and so forth in it I could
reach. Apparently, a stupid move was to go into config mode and type the
following
interface vlan 300
At that point, my telnet management session went away and the switch
is no longer reachable via management any longer, although otherwise
continues to function. I am sort of at a loss to understand what the
problem is but would love to know so a) I don't do it again and b) to
know if there's a way to recover from remote since it's (naturally!) in
a very difficult to acccess location, and having management access again
would be helpful.
Thanks.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
